Functions of Lathe Machine Parts

Head Stock Assembly: Head inventory is usually installed on the left side of this lathe machine. The throw is attached to this component of the lathe. With the support of Chuck, the rotary movement is moved into the work part.

Clutch: Clutch controls the rate of the drive engine and gives a smooth vibration free movement.

Cross Slide Gives the cutting movement of this tool. Cross Slide may be controlled by hand or from the cross feed gear.
Processor Pan: It’s located at the lower portion of this lathe machine. Its role is to gather the chips while machining. Thus these chips could be gathered easily and may be removed.

Feed Rod: Press pole is a powerhouse mechanism that offers precise longitudinal movement of this carriage. For turning operation motion of the feed, the pole is required. In certain lathes feed might not be accessible and direct crystal serves the use of the feed rod.

Lead Twist: Lead screw thread is located just under the feed pole. Additionally, it offers exact longitudinal movement into the carriage. It’s participated in thread cutting performance.

Bed: Bed is your foundation where all of the lathe components are mounted. It’s normally a single piece cast part made from cast iron. Cast iron is utilized due to its self-lubricating property. Different kinds of lathe machines have various sizes of mattress.

Ways: Ways will be the guide rails in by which different areas of the lathe machine goes. It’s used for the exact motion of the carriage along with other mounted components. Ways can be internal approaches and outside ways.

Carriage: Movement holds the resources and offers motion of the instrument in both cross and longitudinal directions. For instance turning and facing cross feed is utilized for conventional rotation carriage offers a longitudinal feed. The carriage comprises various additional pieces. It runs throughout the outside manners. Read more.

It offers a great help to damp the vibration. It’s typically mounted on the interior manners.

Its job is to offer a cross feed of this tool, and its motion is vertical to the middle of this lathe machine.

Compound Rest: the Compound remainder is put around the cross slide, and it might proceed in a circular route.

Tool Post: It’s situated on the peak of the carriage.

Emergency Stop Button: This button can be useful for turning off the device when there’s danger involved while working on the system.

These are the most frequent sections of lathe machines that are usually required to operate the system. However, CNC lathe components are very different from this components.

Learn More